triadagod.blogg.se - How to can i get the printer to print draker

When the Customer Mode menu appears with * Printer and FAX/Scanner displayed, press the Select button to choose Printer.Release your fingers from the keys when the message Please wait.Hold down the Up and Down arrow buttons on the printer and power the printer on.Remove the packing tape by pulling straight out ( Figure 2).įigure 2: Packing Tape on PHD ( 1 - Protection Layer, 2 - Packing Tape).Lift up the PHD unit from the printer. Be careful to avoid scratching the transfer belt.Rotate the four stoppers of the PHD counterclockwise 90 degrees to release the locks ( Figure 1).Do not cover the left and right of the belt guards with the paper. Put a piece of paper on the transfer belt to protect it from scratches and from light damage.Remove the packing tape from the Print Head Device (PHD).To reinsert the PHD unit, follow steps 3 through 5 in reverse.Be careful to avoid scratching the transfer belt. Lift up the PHD unit from the printer.Remove the PHD unit toward you by pulling it by the left and right handles.Rotate the four stoppers of the PHD counter clock wise 90 degrees to release the locks ( Figure 1).(Don't cover the left and right of the belt guards with the paper.) Press the Start button to begin copying.īefore performing any of the procedures in this section, read and follow the safety instructions in the User's Guide.Press the Right or Left arrow button to change the setting to Normal, then press the Select button.Press the Down arrow button to scroll to Lighter/Darker.When the printer is Ready ( Copy, Scan, Fax appears in the LCD), press the Up or Down arrow button to scroll to Copy,.Verify the Copy Lighter/Darker Settings.Verify that toner saving mode has not been selected in printing preferences.Verify the Toner Cartridge is Dell-branded and has not been refilled.None of the Toners has reached end of life:.You can purchase a new toner cartridge for your Dell printer from the following web site: Dell Printer Supplies If the toner runs out due to normal use, a new cartridge must be purchased. Toner cartridges do not contain an unlimited supply of toner. Toner(s) has(have) reached end of life: Purchase a new Toner Cartridge(s).Determine if any toner cartridge reached end of life.Click the Printer Settings button to print the report.Choose the Reports option from the list at the left side of the page.

Open the Tool Box and go to the Printer Settings Report tab.

Yellow Toner Cartridge: 3000 pages, High Yield: 9000 pages Magenta Toner Cartridge: 3000 pages, High Yield: 9000 pages

Check the Total Impressions under General to determine if the toner has reached the end of its lifecycle.īlackToner Cartridge: 4000 pages, High Yield: 9000 pagesĬyan Toner Cartridge: 3000 pages, High Yield: 9000 pages.

System Settings should be the first report option indicated. If so, then just press the select button to print the report. If not, then press the Right or Left arrow button until System Settings is indicated, then press the select button to print the System Settings report.

Press the Down arrow button to scroll to Reports, then press the select button.

With the printer turned on, press the Down arrow button until you highlight SETUP, then press the select button.

If the environment is in scope, print a system settings report and check toner capacity.

Verify the printer's print quality environment temperature is between 50° F ( 10° C) with 15% humidity and 80° F ( 26° C) with 85%.

When there is no different print media available, take out the top half of the stack and flip it over.

Open a new ream of paper that is stored in the same area as the printer.įanning the paper helps break apart paper bonds formed by static or excess humidity.

Verify the print media installed is compatible with the printer.įor more information about the types and sizes of print media that can be used for a specific tray, refer to the Online User's Guide.